Windows NT 4.0 Driver Installation | Rosewill RC210 manual

E-SATA 1.5G 1+1 Port PCI Adaptor RC210		User Manual

device is working properly is displayed in the dialog box, the driver has been correctly installed. If any error message is displayed, remove Silicon Image Sil-3x12 SATALink Controller and restart your system.

2.3. Windows NT 4.0 Driver Installation

For New Windows NT 4.0 System

1.Before installation, copy all the files under directory E:\SATA Non-Raid_2Port\ Sil3x12\ Win98_ me _2000_xp_nt4.0\ driver\ *.* to a blank floppy disk.

2.After the SATA PCI Host Adapter and attached drives are configured, follow Microsoft procedures to install Windows accordingly.

3.At the Windows Set-up screen, press F6 to specify and add the driver.

4.Press S, select Other, then press Enter.

5.Insert the Driver diskette and press Enter.

6.Select Silicon Image Sil-3x12 SATALink Controller Driver and press Enter.

7.Press Enter to continue and follow on-screen instructions to complete Windows NT 4.0 installation.

Add Windows NT 4.0 Driver on Original Booting Device

1.After the SATA PCI Host Adapter and attached drives are configured, boot up Windows. Double click My Computer/Control Panel/SCSI Adapters, then click the Drivers tab.

2.Click Add… then Have Disk....

3.Insert the Driver CD in your CD-ROM/DVD drive and type in E:\ (If your CD-ROM/DVD is E:\), then click Browse.

4.Points specify a location, example E:\SATA Non-Raid_2Port\ Sil3x12\ Win98_me _2000_xp_ nt4.0 \ Driver, click Open then OK.

5.Highlight Silicon Image Sil-3x12 SATALink Controller and click OK.

Verification of the Proper Installation for Windows NT 4.0

1.Double click My Computer/Control Panel/SCSI Adapters.

2.Highlight Silicon Image Sil-3x12 SATALink Controller and click Properties. This device is working properly is displayed in the dialog box, the driver has been correctly installed.

2.4. Windows 2000 Driver Installation

For New Windows 2000 Systems

1.Before installation, copy all the files under directory E:\SATA Non-Raid_2Port\ Sil3x12\ Win98_ me _2000_xp_nt4.0\driver\ *.* to a blank floppy disk.

2.After the SATA PCI Host Adapter and attached drives are configured, follow Microsoft procedures to install Windows accordingly.

3.At the Windows Set-up screen, press F6 to specify and add the driver.

4.Insert the Driver diskette. Press S, then press Enter.