IDE 3-in-1 (5.25”,3.5”,2.5”)to USB 2.0 Cable Converter Adapter RCW607 | User Manual |
| | |
| | |
5.Plug the USB2.0 cable to PC and wait for PC auto-detection. Driver is needed only in old system such as Windows 98. Please inset the driver disk when your system can’t complete the installation process. Windows will auto-install after it detects the driver disk and choose the most suitable driver for your system. (Please notice the direction of USB port)
Notification
1.Please take off your ATA / ATAPI device from RCW-607 only after you turn off the power to avoid any damage.
2.If you plug RCW-607 and hard drive to PC, PC might freeze during the beginning of booting. In this case, you may unplug RCW-607 at the start of booting and re-plug it after PC enters windows.
3.If PC can’t detect RCW-607 and hard drive in your OS, please try the following steps.
1.Unplug RCW-607 and try to reboot the PC.
2.Re-plug it after system enters the OS.
3.If all above still can’t help, it might be caused by the incompatibility between hard drive, system and controller chipset. Please contact us for furthur support.
Trouble shooting
i. Q: I completed the installation by following the menu but MS Windows can’t detect any hard drive.
A:The reason of the problems could be:
1.Hard drive has not completed the format or F-disk process.
*Solution: Format or F-disk your hard drive.
2.The hard drive failed.
*Solution: Replace a workable hard drive.
3.Bad USB connection.
*Solution: Unplug the USB connection and re-connect the USB again.
4.Check LED light on the adapter. If the red LED light on RCW-607 is not on after connected with PC, this adapter is not working correctly.
