Return to On-Line Data Mode, Speaker Volume

PCI 56Kbps V.92 Data/fax Voice Modem Card RC403		User Manual

Result Codes

OK <value> = 0 or 1.

ERROR Otherwise.

O - Return to On-Line Data Mode

This command specifies that the modem will enter the on-line data mode from the on-line command mode with or without a retrain. If in the off-line command mode when this command is entered, the modem reports ERROR.

Syntax

O[<value>]

Defined Values

<value> Decimal number corresponding to the selected option.

0Enters on-line data mode from the on-line command mode without a retrain. Handling is determined by the Call Establishment task. Generally, if a connection exists, this command connects the DTE back to the remote modem after an escape (+++).

1Performs a retrain then enters on-line data mode from the on-line command mode.

Result Codes

OK <value> = 0 or 1 and a connection exists. ERROR Otherwise or no connection exists

L - Speaker Volume

This command sets the speaker volume control according to the parameter supplied.

Syntax

L[<value>]

Defined Values

<value> Decimal number corresponding to the selected option.

0Low speaker volume.

1Low speaker volume. (Default.)

2Medium speaker volume.

3High speaker volume.

Result Codes

OK <value> = 0 to 3.

ERROR Otherwise.

M - Speaker Control

This command controls speaker on or off according to the supplied parameter.

Syntax

M[<value>]

Defined Values

<value> Decimal number corresponding to the selected option.

0Speaker off.

1Speaker on during call establishment, but off when receiving carrier. (Default.)

2Speaker on.

3Speaker is off when receiving carrier and during dialing, but on during answering.

Result Codes

OK <value> = 0 to 3. ERROR Otherwise.