Rosewill AC1200UBE user manual Enable Wireless Protection in Advanced tab

Page 44

Wireless 11ac Dual Band USB AdapterAC1200UBEUser Manual

	4. The access point you wish to connect only allows network
		cards with specific MAC address to establish connection.
		Please go to “About” tab and write the value of
		“Phy_Addess” down, then present this value to the owner
		of access point so he / she can add the MAC address of
		your network card to his / her access point’s list.

The network is slow / having	1.	Move closer to the place where access point is located.
problem when transferring	2.	Enable “Wireless Protection” in “Advanced” tab.
large files	3.	Try a lower TX Rate in “Advanced” tab.
	4.	Disable “Tx Burst” in “Advanced” tab.
	5.	Enable “WMM” in “QoS” tab if you need to use multimedia /
		telephony related applications.
	6.	Disable “WMM – Power Save Enable” in “QoS” tab.
	7.	There could be too much people using the same radio
		channel. Ask the owner of the access point to change the
		channel number.
	Please try one or more solutions listed above.

44

Image 44

Contents Wireless 11ac Dual Band USB Adapter AC1200UBE Table of Content Connection Profile ManagementSupport techsupport@rosewill.com Call Center 800 FAX 626 Safety Information Package Content FeaturesOverview System RequirementLED Status WPSInstallation Guide Hardware DiagramUsing Realtek Utility Connect to Wireless Access Point Will restart my computer laterAC1200UBE AC1200UBE Using Windows Zero Configuration Check Windows Zero Config boxAC1200UBE Double click Network Connections Networks AC1200UBE Connection Profile Management Add a new profile Ascii / Passphrase Remove an existing profile PACAC1200UBE Edit an existing profile Set as default profile Make a copy of existing profileNetwork Statistics, General Information, and Status General InformationStatus AC1200UBE View Network Statistics Miscellaneous Settings HereEstablish secure connection with AP by WPS Click Wi-Fi Protect Setup menu PIN Code AC1200UBE Push Button Switch to AP Mode and Station Mode Soft-AP FunctionAC1200UBE Configure Ssid and Channel Wireless Network Properties is displayed Setup Soft-AP Security Advanced Settings Wireless Statistics Internet Connection Sharing ICS Appendix a Product Specification LEDAppendix B FAQ Launch config utilitiesEnable Wireless Protection in Advanced tab Disable WMM Power Save Enable in QoS tabWhat is the Ieee 802.11g standard? Appendix C GlossaryWhat is BSS ID? What is Spread Spectrum? Federal Communication Commission Interference Statement RF Exposure Information SAR