Technicolor - Thomson CS520 manual Getting Started, Unpacking the system, Back View, Installation

CS520 EN 2/23/04 3:56 PM Page 7

Getting Started

Unpacking the system

You should have the following:

•one main unit (with 2 main speakers);

•one remote control;

•one FM antenna;

•one AM loop antenna;

•one user’s guide;

•one Thomson Warranty Card

Back View

Connecting the Speakers EN

Match the red wire (on the left speaker) to red terminal for the left speaker (L) on the back of the unit and the black wire (on the left speaker ) to the black terminal for left speaker (L). Follow the same procedure to connect the right (R) speaker.

Speaker Wire Connection

R L

RL

+ +

AUX IN

MAIN SPEAKERS 6Ω

4

3

1	2
AM LOOP
	FM 75Ω

Push Speaker terminal tab	Release tab to lock wire in
down to insert wire.	the terminal.

NOTE: Make sure the insulation is completely removed from the ends of the speaker wires at all connection points.

Installation

To ensure sufficient ventilation, keep the spacings shown below free from other surfaces:

1.AM Loop antenna Jacks.

2.FM Antenna Connector.

3.Main Speaker Jacks.

4.Aux In.

Using the FM and AM Antennas

Before you use your audio system, you’ll want to make sure both the FM and AM antennas are positioned properly. Connect the FM antenna to the FM connector on the back of the unit. Uncoil it, making sure it is fully extended. (you may even want to tape it to the wall behind the unit if possible. The higher the better.)

You’ll also need to connect the AM antenna loop to the back of the unit if you listen to AM stations. Rotate the AM loop antenna for better reception.

Front View	10 cm
	mp
10 cm	10 cm
	5 DISC CHANGER

Side View	10 cm
5 cm

2