Rose electronic MAN-V8 manual Operations, Operating instructions, Keyboard command

OPERATIONS

Operating instructions

The Vista switch is very easy to operate. Computer selection and set-up functions are entered from the keyboard. You can also select computers manually from the Vista’s front panel by using buttons 1-2 or buttons 1-4 depending on your model.

Keyboard command

Following is a description of the Vista keyboard command functions.

The <Ctrl> input key sequence is a press and release of the left control key. Within 2 seconds of pressing and releasing the left <Ctrl> key, enter the next command.

Command	Key Sequence	Description
Reset	<Ctrl> R	Resets and enables mouse and
command		keyboard, enables PS/2 mouse
		on currently selected port.
Reset mouse	<Ctrl> O	Sends reset mouse command to
command		currently selected CPU. Will
		recover stuck NT mouse.
Send null byte	<Ctrl> N	Used to re-synchronize PS/2
		mouse.
Identify ROM	<Ctrl> I	Identifies ROM version, CPU
version		must be at a command prompt,
		word processor, or text editor to
		receive value.
Keep	<Ctrl> K	Saves current scan state and
		custom settings.
Scan time	<Ctrl> Txx <Enter>	Sets the pause time for each
interval	(xx = 1 – 16 sec.)	port when scanning.
Mode	<Ctrl> M x <Enter>	First select the CPU port to
command	Where:	configure, and then enter the
	x = 1 for mode 1	mode command.
	x = 2 for mode 2	Mode 1, 2, 3 for keyboard:
	x = 3 for mode 3	Mode 7, 8, 9 for mouse
	x = 7 for mode 7
	x = 8 for mode 8
	x = 9 for mode 9

12Vista KVM-Series Installation and Operations Manual