Rose electronic MAN-V8 manual Flash Upgrade Procedure, KVM Flash Upgrade Utility

Page 21

FLASH UPGRADE PROCEDURE

KVM Flash Upgrade Utility

Installation of KVM Utility

The installer for the KVM Utility may be distributed in one of two formats: a ZIP file or an EXE.

If the installer is distributed as a ZIP file, open it in WinZip and unzip the contents to a known location. The ZIP file contains the EXE format.

Double-click on the EXE file and follow the on-screen instructions to install the KVM Utility. Installation is a standard Windows type installation. After installation, the KVM Utility can be launched from the Desktop, the Start Menu and/or the Quick Launch bar to the right of the Start button on the Taskbar.

Hookup of Device

The KVM flash upgrade utility is a universal program used to flash several models. In order for the KVM Utility to detect the correct device to flash, it must be connected directly to a PC and the PC must be connected to port 1 on the switch.

Running the KVM Utility

When the KVM Utility has been successfully installed, it can now be run. If the device has been hooked up as described above, the KVM Utility will auto-detect the device when it is launched and display the connected device. Otherwise, it will display a message that an incorrect device has been connected.

Once the KVM Utility has detected the device correctly, the device may be flashed or configured from the File Menu. The following page summarizes the installation procedure.

More Information

The Quick Start Guide that follows provides a step by step procedure for installing the firmware upgrade. This upgrade procedure can only be performed on firmware versions KVM-V5x or greater. Older model chips are not flash upgradeable. You must upgrade firmware chips on these models.

Vista KVM-Series Installation and Operations Manual 17

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Vista KVM-SERIES Installation and Operations Manual Limited Warranty FCC/IC STATEMENTS, EU Declaration of Conformity Table of Contents Introduction DisclaimerIntroduction Product Registration FeaturesCompatibility Package contentsSystem overview OverviewKVM station CPU connectionsRose Electronics web site Power connectorsVista KVM-Series models ModelsDB9F Label Connector type DescriptionMiniDin-6F or KVM PS/2 or Mouse Serial mouse Installation InstallationConnecting the KVM station Applying power Connect the CPUsVerify keyboard, mouse and CPU operation Vista to CrystalView Rack mountingCommand Key Sequence Description Keyboard commandOperations Operating instructionsKeyboard commands Command Key Sequence Description Keyboard command description Reset computer mouse type NT and WIN 2K systems only ResetKeep command Mode commandReset to initial factory settings Typematic commandMaximum computers Mouse typeKVM Flash Upgrade Utility Flash Upgrade ProcedureVista KVM-Series Installation and Operations Manual Vista KVM-Series Installation and Operations Manual TroubleShooting TroubleshootingVideo fuzzy Cannot remember the configuration or access passwordMouse does not move Video not synchronized or wrong colorService Maintenance and repairTechnical support Safety SafetySafety Information Safety and EMC regulatory statementsGrounding ServicingSafety and EMC regulatory statements Appendices Setting Default ValueVista Part Numbers Description CPU Adapter Cables for Models with PC ConnectorsRackmount Kits Appendix C. General specificationsAppendix E. Rack mount illustration Typematic Rate Typematic DelayPage Stancliff Road Phone 281 Houston, Texas
Top Page Image Contents