16
your SOLO radio to communicate with your network. Please note that the SOLO does not currently support WPA2 Business.
Only the person who set up the network in the first place knows this password; if that person is not you then you need to find out the password. You can do this by checking with the Customer Service of your internet provider or the manufacturer of your wireless router.
After approximately 3 seconds, the display goes into the password entry mode:
< END
◄ ► A | BCDEF> |
█ |
|
To enter the password, use the SCROLL to select each letter/number/symbol of the password in turn. When the 1st letter or number of your password is in the center of the display, press the large dial inward to select that letter or number. Repeat this process for each letter or number in your password.
NOTE: WEP and WPA passwords are upper and lower case sensitive and MUST be entered exactly
HINT: Use the ’Back’ button to erase incorrect characters that you may have entered. IF the display shows: “Invalid key” or “Network Error”, an incorrect password has been entered.
After entering the final letter/number/symbol, scroll to find and select END . The word ‘END’ is in the center of the display press the large dial inwards.
Once the password is entered correctly, your SOLO should now be able to connect to the network.
Your radio should now be able to connect to the selected network without having to
NOTE: IF you would like to give your radio a static IP address then please see the ‘Network config’ section under the ‘Setting’ section.