Connecting Wireless Rear Speakers

1 Connect your pair of	2 Insert the power plug into an outlet,
wireless rear speakers,	and then press the POWER button
(L) and (R), to the	on the front panel.

Caution

• Do not connect the wireless rear speakers

to the speaker outputs on the back of the

Resetting Wireless Communication

Reset the system if a communication failure occurs, or if the synchronizing signal indicator does not light up and the "REAR CHK" message blinks on the main unit's display.

Reset the system while the main unit and the wireless rear amplifier (SWA-1000) are in Power Standby mode.

wireless rear amplifier.		• The Power Standby indicator will light up.
		• To turn off the wireless rear amplifier,
		press the POWER button in Standby mode.
Wireless Rear Speaker (L)	Wireless Rear Speaker (R)

main unit. Malfunction may result.

• The wireless receiving antenna is built into

the wireless rear amplifier.

Keep the unit away from water and

moisture.

• For optimal listening performance, make

sure that the area around the proposed

wireless rear amplifier location is clear of

any obstructions.

1 With the main unit turned off, press and hold the remote control's WIRELESS button for 4 seconds.

•Press the button until the volume control indicator lights up blue. (The indicator will turn off in 1 second.)

2 With the wireless rear amplifier turned on, use a ball point pen or a pair of tweezers to press the RESET button on the back of the unit 2 to 3 times.

RESET Button

Back of Wireless Rear Amplifier

CONNECTIONS

Back of Wireless Rear Amplifier

3 Turn on the main unit.

• The wireless rear amplifier's synchronizing signal indicator will light up.

• If Power Standby mode continues, repeat Steps 1 to 3 above.

Caution

• Sound will be heard from the wireless rear speakers in

DVD 5.1-CH or Dolby Pro Logic II mode only.

• In 2-CH mode, no sound will be heard from the wireless

When using the wireless transmission antenna

Stand the wireless transmission antenna to face upward for best communication status.

Caution

• Do not apply a strong shock to the wireless transmission antenna. Breakage may result.

• Do not touch the wireless transmission antenna during operation. Noise or interference to communications may result.

Note

• Place the wireless rear amplifier at the rear of the listening position. If the wireless rear amplifier is too close to the main unit, some sound

interruption may be heard due to interference.

• If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that uses the same frequency

(2.4GHz) near the system, some sound interruption may be heard due to interference.

• The transmission distance of radio wave is about 33 feet but may vary depending on your operating environment. If a steel-concrete wall or

metallic wall is between the main unit and the wireless rear amplifier, the system may not operate at all because the radio wave cannot

penetrate metal.

rear speakers.

Turning On the Mood Light

You can turn the mood light on the wireless rear amplifier on or off, as well as change the light to one of 7 different colors according to your preference.

1 Press the POWER button on	2	Press the COLOR MODE button.
the wireless amplifier.		• Each time the button is pressed, the color changes as
• The Power Standby indicator on the		follows: Blue ➞ Light Green ➞ Red ➞ Sky Blue ➞
front panel will light up and the		Yellow ➞ Pink ➞ White.

mood light will turn on.

Turning Off the Mood Light

• In Power Standby mode, press the ON/OFF button on the Wireless amp.

The mood light will light up or turn off with the last color selected.

Turning off the Wireless Amp and Mood Light

• Press the POWER button on the wireless amp.

	The wireless rear amplifier and the mood light will turn off.	14
	When the wireless amp is powered on again, the mood light will be blue.	14