Powerware 5105 warranty Technical Specifications

Technical Specifications 1

Advanced Battery Management (ABM™) Technology Doubles Battery Service Life

The lead-acid batteries typically used in a UPS are considered viable as long as they can maintain backup times of at least half that of new batteries. The illustration to the right shows that batteries that are constantly trickle charged (as are virtually all other UPS batteries on the market today) reach the end of their useful life in less than half the time of batteries charged using ABM. ABM uses a patented three-stage charging technique that not only doubles battery service life, but also optimizes battery recharge time and provides up to a 60-day advanced notifi- cation of pending end of useful battery life.

Data based upon tests performed by an independent battery manufacturer

E L E C T R I C A L IN P U T

Voltage	120 and 230 Vac nominal; see Model Selection Guide for
	user-selectable voltages
Online	-30%, +20% for nominal voltages; user-selectable
Voltage Range	extended range of -35%, +20%
Nominal Input	50/60 Hz; auto-selection
Frequency
Connections	See Model Selection Guide
E L E C T R I C A L OU T P U T
Power Levels	450, 700, 1000, and 1500 VA
Online Efficiency	96%
Online Regulation	-10%, +6%; within Computer Business Equipment
	Manufacturers Association’s Guidelines (-15%, +10%
	using extended range)
On Battery	±5% RMS
Regulation

Voltage Wave Shape Quasi-sine wave

(on battery)

No Load Sleep Mode Outputs are turned off if <5% load is detected (selectable)

Connections See Model Selection Guide

Interconnecting 2 ea. IEC-320 (10 A); 230 Vac models only

Cords(cabinet)

P H Y S I C A L
Dimensions and	See Model Selection Guide
Weight
Surge Suppression High energy 6500 peak Amp
Audible Noise	Less than 45 dB
Operating Temp	0°C–40°C (32°F–104°F)
	UL tested at 25°C (77°F)
Operating Humidity 5 to 95% non-condensing
Operating Altitude	Up to 10,000 feet above sea level
Conformance	IEEE 446, NEMA PE 1;
Standards	ANSI C62.41; FCC Class A and B, EN50091-2
	Class B, NSTA and others
Safety Standards	UL 1778, CSA C22.2, and European standard
	EN 50091-1
Network Transient In and out RJ11 jack for telephone/modem
Protector	protection (120 Vac models only) or RJ45 for
	10Base-T network cable; UL497A tested
P O W E R P R O T E C T I O N
Series 5	Protection against power failures, power surges,
Protection	power sags, brownouts, line noise, and a degree of
	protection against other power problems

1. Due to continuing product improvement programs, specifications are

Interconnecting	4 ea. IEC-320 (10 A)
Cords(rack)
Backup Time	See Battery Run Times table
Battery Charging	<4 hrs to 90% usable capacity

subject to change without notice.

Front Panel Display

Battery Type	Sealed, maintenance-free lead-acid
Start-On-Battery	Startup with UPS batteries in absence of utility power
IN D I C AT O R S A N D C O N T R O L S
Serial	Intelligent serial communication to provide alarms
Communication	with history, measured parameters, selftest, and many
	other features.
Front Panel	Ergonomic indicators including wiring fault, battery
Interface LEDs	service, communication operation, system normal; bar
	graphs for input level, battery charge level, % load
Digital Input/Output	Remote On/Off

Input Voltage Level

Site Wiring Fault

ABM (up to 60-day notice for battery service)

On Button (Start-on-battery)

Battery Level

Load Level

Communications

Off/Standby

Button

Alarm Silence/

Self-test Button