58Adding and removing a node
Removing a node from a cluster
4Remove system03 from the system list attribute of the CVM and SFCFS service groups:
#hagrp
#hagrp
where service_group is the command that displays the service groups by hagrp
If an error message similar to the following is displayed by either of the above commands:
VCS:10456:Configuration must be ReadWrite. (’hagrp
Repeat step 3 and the command that failed in step 4.
5Write the new VCS configuration to disk:
#haconf
6Edit /etc/llthosts on the remaining nodes of the cluster, and remove the entry corresponding to the node being removed.
7Edit /etc/gabtab on the remaining nodes of the cluster and edit the gabconfig command to reflect the correct and new number of nodes in the cluster.
8Login to system03 and remove the following files:
#rm /etc/vxfenmode
#rm /etc/llthosts
#rm /etc/llttab
#rm /etc/gabtab
9If fencing was enabled on the cluster, run the following commands:
#rm /etc/vxfentab
#rm /etc/vxfendg
10If necessary, modify the /etc/gabtab file. No change is required to this file if the /sbin/gabconfig command has only the argument
Modify /etc/llthosts file on each remaining nodes to remove the entry of the leaving node.
11Change to the install directory:
# cd /opt/VRTS/install