SUPER MICRO Computer IRV-3702 user manual Completing the Installation

Page 16

2.Push the PROMDISK-Chip into the socket carefully until it is fully seated.

3.Check to make sure the PROMDISK-Chip is installed securely, and there are no bent pins.

To remove the PROMDISK-Chip, insert a small screwdriver between the PROMDISK-Chip and the socket and gently pry around the edge until the PROMDISK-Chip is released from the socket.

COMPLETING THE INSTALLATION

To complete the installation, the following steps should be followed:

1.Set the configuration jumpers in accordance with Appendix E.

2.Install the IRV-3702 SBC into the CPU slot in a passive backplane.

3.Connect the applicable I/O cables and peripherals, i.e. floppy disk, IDE hard disk, monitor, keyboard, power supply, etc.

4.Connect an IBM PC compatible keyboard.

5.Turn power on to the display monitor.

6.Turn power on to the backplane power supply.

7.After the BIOS sign-on message is displayed, press the Del key to enter the Setup Utility.

8.Reconfigure the IRV-3702 CMOS using the internal SETUP.

9.Boot the system.

10

Image 16

Contents Micro Computer SPECIALISTS, INC Page Preface Page Table of Contents Page Features IntroductionSystem Description ProcessorSystem Memory Sdram DMA ControllerTimers Interrupt ControllerCLOCK/CALENDAR and Cmos RAM Keyboard PortReset Switch Mouse PortSpeaker Port Printer PortWatchdog Timer Eide Hard Disk PortOptional PROMDISK-CHIP Disk Emulator High Speed PCI Expansion BUSEthernet Port Universal Serial BUS Port Irda Infrared Interface PortSetup Using ROM-DOSAND Other Disk Operating Systems Using the PROMDISK-CHIP Disk EmulatorPromdisk LOW Level Format Installation Installing the DimmsInstalling the CPU Installing the PROMDISK-CHIPCompleting the Installation Appendix a Specifications CPUAppendix B Board Outline Appendix C Memory and I/O Maps IRV-3702 SBC Memory Map Address Used For SizeIRV-3702 SBC I/O Map Address FunctionAppendix D Connectors CN8 Keyboard Header/ConnectorCN18 Keyboard/Mouse Connector PS2 type CN7 Keylock Header/ConnectorCN1 & CN3 IDE Hard Disk Port Connectors CN4 Printer Interface ConnectorCN5 Ethernet LED Connector CN10 Ethernet RJ45 ConnectorCN12 Serial Port #1 9-pin Sub D Connector CN11 Serial Port #2 10-pin Header/ConnectorJ1 VGA Display Connector 15-pin Sub-D CN7 Speaker Port Header/ConnectorCN7 IDE LED Header/Connector CN17 PS2 Mouse Header/ConnectorCN9 Universal Serial Bus Ports 1 & 2 Connector CN6 IrDA Infrared Port ConnectorAppendix E Configuration Jumpers JP15Multiplier TimeJP4 Clear Cmos Setup Jumper Appendix F Bios Error Beep Codes