EZ Switch 10/100/1000
TROUBLESHOOTING
Diagnosing Switch Indicators
1.Symptom
Power LED does not light after power on.
Probable Causes
• DC power socket may be defective.
Possible Solutions
•Check for loose connections.
•Check the power outlet by using it for another device.
2.Symptom
Link LED does not light after connection is made.
Probable Causes
•Switch port, network card or cable may be defective.
Possible Solutions
•Check that the switch and attached device are both powered on.
•Be sure the network cable is connected to both devices.
•Verify that Category 5 or better cable is used for 10/ 100 Mbps connections, Category 5 or 5e cable for 1000 Mbps connections, and that the length of any cable does not exceed 100 meters (328 feet).
•Check the network card and cable connections for defects.
•Replace the defective card or cable if necessary.
8