1:Features and Capabilities of the SGI 10-Gbit Ethernet Network Adapter
•"Configuration Limits" on page 3
•"Tools" on page 3
Features
The adapter includes the following features:
•Full-duplex Gigabit Ethernet interface as defined in the IEEE P802.3ae approved standard
•Jumbo frame support (up to 9600 bytes)
•16 DMA channels (8 for reading, 8 for writing)
•Single LC fiber connection
•Support for PCI 64-bit 66-MHz and PCIX 66/100/133-MHz
•Universal dual-voltage signaling (3.3 V and 5 V)
•Compliance with PCI Local Bus Specification (Revision 2.3) and PCI-X Addendum to the PCI Local Bus Specification (Revision 1.0a) standards
•Optical cabling 850–nm (10GBASE-SR)
•TCP large-send offload
•TCP large-receive offload (Release 2 only)
•UDP large-send offload (Release 2 only)
Cabling
The adapter is an LC connector and uses a 10GBASE-SRtransceiver at 850–nm. It is connected to the network using a multimode fiber (MMF) cable of 50-micron. The cable (which is not included in the shipment) must have a quality in the range from 400-MHz * km to 2000-MHz * km, depending on its length, as shown in Table 1-1.
