Samsung MM-DS80M instruction manual Listening to a Cassette, Repeat A↔ B Function

Listening to a Cassette

Always treat your cassettes with care; refer, if necessary, to the section entitled “Precautions When Using Audio Cassettes” on page 56.

REPEAT A↔ B Function

Press REP. A↔ B button.

• Use this to listen to a specific section again during playback.

•Set the start and end points of the section you want to repeat 3 times.

• This is a useful when learning a foreign language.

• The TAPE REPEAT function can be used only on sections that are longer than 7 seconds.

Note	•	You cannot set the end point (B) within 7 seconds after
		setting the start point (A).

Switch the system	Press TAPE on
on by pressing	the player to
1 POWER.	2 select the Tape

function.

Press the PUSH

3 EJECT ( ) of the cassette deck to open the cassette door and insert a cassette.

•Insert a cassette with the recording/playback side facing the cassette holder, and then push the cassette door shut.

Selecting the Cassette Playback Mode

Your micro component system has three cassette playback modes which enable you to listen to both sides of a cassette automatically.

Press REV.MODE until the appropriate symbol is displayed.

	Press the		Press the	,			When you have
4	button. The cassette		5 button if necessary.			6	finished playback,
	starts playing.						press STOP button.
• Side A : Tape (		) button once.	• Rewind the cassette		/ DOWN
• Side B : Tape (		) button twice.	button.

•Fast-forward the cassette UP / button.

• : One side of the selected cassette and then stops.

• : One side of the cassette.

The other side of the cassette and then stops.

• : Both sides of the cassette indefinitely until you press stop.

TAPE DECK

45 46