SMC Networks SMC1255TX manual PCI Compatibility

Page 47

PCI COMPATIBILITY

Older computers may require you to reserve interrupts and memory addresses for installed ISA cards to prevent PCI cards from using the same settings. Refer to your PC’s manual and check the PCI BIOS setup program configuration options for ISA cards.

Make sure the PCI slot is configured to support INTA.

Ensure that INTA for the slot is assigned to a free interrupt (IRQ) number.

Check the BIOS setup program’s PCI parameters for the slot where the network card is installed. Ensure that the slot is configured for level-triggered interrupts instead of edge-triggered interrupts. An example of typical PCI parameters follows:

PCI Slot #:

(slot number where the network card

 

is installed)

Master:

Enabled

Slave:

Enabled

Latency Timer:

40 (range is 20 to 255)

Interrupt Type:

Level-Triggered

Interrupt Number:

(choose any number the BIOS setup

 

supplies that does not conflict with

 

another installed card)

Note: The wording of these parameters varies with different computers, and not all parameters may be configurable.

Always consult your computer manual for information on changing motherboard jumper settings and BIOS setup program parameters for use with PCI network cards. If you set a motherboard jumper and modify the computer’s BIOS setup, make sure the jumper and BIOS settings match.

37

Image 47
Contents SMC1255TX Page Barricade PCI User Guide Trademarks CopyrightLimited Warranty Limited Warranty Vcci Class B Compliance Japan CompliancesFCC Class B FCC Radiation Exposure StatementSMC contact for these products in Europe is EC Conformance Declaration Class BTable of Contents Specifications TroubleshootingCable Specifications Introduction Features and Benefits Hardware Description RJ-45 LED IndicatorsRemote LAN Wakeup Equipment Checklist InstallationHardware Installation Installation Driver Installation Click Next Check Specify a location, and click Next Driver Installation Installation Software Installation Installation Software Installation Installation EtherGuard Installation Software Installation Installation Software Installation Installation WiNeTool MAC ConfigurationSoftware Installation Send Packet Packet Generator Send Acpi Packet Receive Packet Gauge Click Analysis to open the capture console Capture Console ToolbarFilter Setting MAC Address Filter Setting Protocol Filter Setting IP AddressFilter Setting Buffer Size Filter Setting PatternPacket Analysis Receive Packet Detail PCI Compatibility TroubleshootingPCI Compatibility Network Card Installation Problems Solutions for Common ProblemsNetwork Connection Problems Troubleshooting Twisted-Pair Cable and Pin Assignments Cable SpecificationsCable and Specifications RJ-45 Pin Assignments Specifications Unix Drivers WarrantyCompliances NetWare ODI DriversFor Technical SUPPORT, Call