SMC Networks SMC2804WBR38 manual 10/100 LED does not light after a connection is made

Page 78

Troubleshooting

3.Then type ipconfig/renew.

D. The 10/100 LED does not light after a connection is made.

1.Check that the host computer and hub are both powered on.

2.Be sure the network cable is connected to both devices.

3.Verify that Category 5 cable is used if you are operating at 100 Mbps, and that the length of any cable does not exceed 100 m (328 ft).

4.Check the network card connections.

5.The 10BASE-T/100BASE-TX hub/switch port, network card, or cable may be defective.

68

Image 78

Contents C 2 8 0 4 W B R Page Page Copyright FCC Class B FCC RF Radiation Exposure StatementEC Conformance Declaration Class B Line ±1kV, AC/DC Line to Earth ±2kVAustralia AS/NZS 3548 1995 Class B Safety ComplianceIndustry Canada Class B Underwriters Laboratories Compliance StatementWichtige Sicherheitshinweise Germany Table of Contents Table of Contents About the Wireless Barricade G Router LED IndicatorsFeatures and Benefits Installing the Wireless Barricade G Router Package ContentsHardware Description Hardware Description System Requirements Basic Installation Procedure Connect the SystemPower on Connect the power adapter to the Router Connect the System Making the Wlan Connections Attach the Wireless Barricade g Router to the Internet Making the WAN Connection Connecting the Power AdapterInstalling TCP/IP Windows 95/98/MEInstalling TCP/IP WindowsConfiguring Client TCP/IP Setting Up TCP/IP Configuring Your Computer in Windows 95/98/MeConfiguring Client TCP/IP Obtain IP Settings from Your Wireless Barricade g Router Configuring Your Computer in Windows NT Setting Up TCP/IP Configuring Your Computer in Windows Configuring Your Computer in Windows XP Configuring a Macintosh Computer Manual IP Configuration Verifying Your TCP/IP Connection Pinging 192.168.2.1 with 32 bytes of data Request timed out Configuring the Wireless Barricade G Router Browser ConfigurationDisable Proxy Connection Internet Explorer 5 or aboveInternet Explorer For Macintosh Netscape 4 or above Making Configuration Changes Navigating the Web Browser InterfaceSetup Wizard Time ZoneBroadband Type Cable ModemFixed-IP xDSL PPPoEAdvanced Setup Menu DescriptionSystem Time ZonePassword Settings WAN Dynamic IP Point-to-Point Over Ethernet PPPoE Point-to-Point Tunneling Protocol Pptp Static IP Address DNS LAN Wireless Channel and SsidEncryption Advanced Setup Configuring the Wireless Barricade g Router Network Address Translation NAT Address MappingVirtual Server Special Applications Access Control FirewallAdvanced Setup MAC Filtering Table URL Blocking Schedule Rule Intrusion Detection SPI and Anti-DoS firewall protection Default Enabled RIP Defect Default Enabled If an RIP request packet isDiscard Ping from WAN Default Disabled When hackers attempt to enter your network, we can alert Parameter Defaults Description DoS Criteria and Port Scan CriteriaDMZ Ddns Dynamic DNS Settings UPnP Universal Plug and Play Setting Tools Configuration Tools ToolsTools Firmware Upgrade Tools Reset Status Section DescriptionTroubleshooting Verify your connection to the RouterAm getting an IP Address that starts with Have another IP Address displayed10/100 LED does not light after a connection is made Dimensions Advanced FeaturesIndicator Panel WeightTemperature Input PowerPower Consumption SafetyPage For Technical SUPPORT, Call