Xantech DCH4 Operation, Visitors, Entry Phone Caller ID and Call Waiting ID Monitoring

Page 8

OPERATION

A. Visitors

When a visitor presses the call button (comes off-hook) on the entry phone, the DCH4 will begin ringing the house phones and “Caller ID” information is sent. If a house phone is on a C.O. call, call waiting tones and “Call Waiting Caller ID” information is sent. A Touch Tone “#” from the house phone will put the C.O. call on hold and connect the house phone to the entry phone (beeps will be heard, indicating which entry phone you are connected to). Enter Touch Tones “**” to momentarily activate that entry phone doorstrike and return to the C.O. call or enter “#” to just return to the C.O. call without activating the doorstrike. If the doorstrike is activated, a buzz sound will be heard confirming the strike has been activated. If you require the door strike to remain on continuously (ie: a truck delivery), enter Touch Tones “*1” to continuously activate that relay and return to the C.O. call. A 5 second buzz sound will indicate the door strike relay is latched on. When the visitor calls in again (ie: they are finished unloading the truck), enter Touch Tones “*0” to deactivate the relay. Alternatively, the doorstrike relay can be de-activated by going off-hook with any house phone and entering #1*0 for doorstrike relay 1, #2*0 for doorstrike relay 2, etc. See Operation section C. A short buzz will indicate the door strike relay is off.

Entry Phone

Caller ID and Call Waiting ID

 

 

1

“Entry Phone 1”

2

“Entry Phone 2”

3

“Entry Phone 3”

4

“Entry Phone 4”

B. Monitoring

Tenants may dial out to an entry phone that supports auto-answering capability by dialing “#1”, “#2”, “#3” or “#4” to call entry phones 1-4 respectively.

C. Activating Doorstrike/Gate

You may activate the doorstrike relay without calling out to the entry phone. Refer to the chart at the right for dialing strings. When you momentarily activate a doorstrike relay, it will activate for the amount of time specified in Programming, section F. * Note: The latch command can be disabled (see Programming section B).

 

Momentarily

 

 

Toggle

 

Activate

* Latch

Un-Latch

Entry Relay

Doorstrike

Doorstrike

Doorstrike

Doorstrike Relay

1

#1**

#1*1

#1*0

#1*#

2

#2**

#2*1

#2*0

#2*#

3

#3**

#3*1

#3*0

#3*#

4

#4**

#4*1

#4*0

#4*#

 

 

08905107C

- 8 -

Image 8
Contents Specifications DescriptionEntry Phone Input Door Strike, Relay Contact Output. N.O., COM, N.OAuxiliary Relay Contact Output. N.C., COM, N.O ApplicationAccessing the Programming Mode Remotely Step ProgrammingLine OUT to Phones OUT to PhonesQuick Programming Features DIP Switch Programming Security CodePrivacy Number Keyless Entry Codes and One Time Use Keyless Entry CodesOutside Line Access Doorbell Switch Input and Auxiliary Contact OutputDoor Strike Activation Time Caller IDAuxiliary Contact Mode DIP Switch 1 OFF Entry Phone Triggered Continuous ActivationEntry Phone Triggered Ring Cadence Activation Auxiliary Input Triggered Timed ActivationOperation VisitorsEntry Phone Caller ID and Call Waiting ID Monitoring Activating Doorstrike/GateOperation Commands Touch Tone Commands Xantech CORPORATION, 13100 Telfair AVE. SYLMAR, CA 91342 818