Seagate ST120HM001, ST120HM000, 600 Drive Mounting, Mounting configuration dimensions 7mm models

3.4DRIVE MOUNTING

You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom- mounting holes. Follow these important mounting precautions when mounting the drive:

• Allow a minimum clearance of 0.030 in (0.76 mm) around the entire perimeter of the drive for cooling as a guideline. Please refer to Section 3.5 for final cooling requirements.

•Use only M3 x 0.5 metric mounting screws.

•Four (4) threads (0.080 in) minimum screw engagement recommended. Also ensure maximum screw length does not bot- tom out in mounting holes.

•Do not overtighten the mounting screws (maximum torque: 4.5 in-lb, ± 0.45 in-lb).

Refer to 4 for detailed mounting configuration dimensions.

See Section 3.4, “Drive mounting.”

Weight:	7mm models	0.170 pounds	77 grams
	5mm models	0.148 pounds	67 grams

Note. These dimensions conform to the Small Form Factor Standard documented in SFF-8201 and SFF-8223 found at www.sffcommittee.org.

Figure 3. Mounting configuration dimensions (7mm models)

SEAGATE 600 SSD PRODUCT MANUAL, REV. B 17