Seagate ST2000VN000, ST3000VN000 manual Drive mounting, Attaching Sata cabling

Page 24

Configuring and Mounting the Drive

www.seagate.com

Figure 1 Attaching SATA cabling

Signal connector

Power connector

Signal cable

Power cable

Each cable is keyed to ensure correct orientation. NAS HDD drives support latching SATA connectors.

3.4Drive mounting

You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes. Refer to Figure 2 for drive mounting dimensions. Follow these important mounting precautions when mounting the drive:

•Allow a minimum clearance of 0.030 inches (0.76mm) around the entire perimeter of the drive for cooling.

•Use only 6-32 UNC mounting screws.

•The screws should be inserted no more than 0.150 inch (3.81mm) into the bottom or side mounting holes.

•Do not overtighten the mounting screws (maximum torque: 6 inch-lb).

Figure 2 Mounting dimensions (2TB,3TB and 4TB)

Temperature

Check Point

24	NAS HDD Product Manual, Rev. A

Image 24

Contents Seagate NAS HDD Document Revision History Revision Date Description of ChangeContents NAS HDD Product Manual, Rev. a Figures NAS HDD Product Manual, Rev. a Seagate Technology Support Services NAS HDD Product Manual, Rev. a Introduction About the Sata interfaceIntroduction Drive Specifications Specification summary tablesDrive Specifications LBA mode Default logical geometryFormatted capacity Physical characteristics Recording and interface technologyPower specifications Power consumptionSeek time Start/stop timesConducted noise Voltage tolerancePower-management modes Environmental specificationsDrive case temperature Power modes Heads Spindle BufferAmbient Temperature Temperature gradientHumidity AltitudeNon-operating vibration AcousticsTest for Prominent Discrete Tones PDTs Electromagnetic immunityWarranty Agency certification Safety certificationReliability Mean Time Between Failure Electromagnetic compatibilityFCC verification Environmental protectionKorean RRL Australian C-Tick N176China Restriction of Hazardous Substances RoHS Directive Corrosive environmentHandling and static-discharge precautions Configuring the driveSata cables and connectors Drive mounting Attaching Sata cablingSata Interface Segment Pin Function DefinitionSupported ATA commands Command name Command code in hexSata Interface EFH Identify Device command Word Description ValueXx7FH Bit Word GPL feature set is supported Set Features command Set Features commands3 S.M.A.R.T. commands Code in features register A.R.T. commandIndex NAS HDD Product Manual, Rev. a NAS HDD Product Manual, Rev. a Page Page Seagate Technology LLC Americas