Seagate 810 manual

Page 4

©1995 Seagate Technology, Inc. All rights reserved

Publication Number: 36300-101, Rev. A, August 1995

Seagate, Seagate Technology and the Seagate logo are registered trademarks of Seagate Technology, Inc. SafeRite and Marathon are trademarks of Seagate Technology, Inc. Other product names are reg- istered trademarks or trademarks of their owners.

Seagate reserves the right to change, without notice, product offerings or specifications. No part of this publication may be reproduced in any form without written permission from Seagate Technology, Inc.

Image 4

Contents Marathon ATA Interface Drive Page Marathon 810 ST9816AG ATA Interface Drive Page Contents ATA interface Drive mounting and configurationAppendix. Compatibility notes Figures Page Introduction Specification summary table Drive Specification ST9816AGRead/Write power and current typical Page Drive specifications Default logical geometryFormatted capacity Supported translation geometriesPhysical dimensions Recording and interface technologyPower specifications Power consumptionSeek time Startup timesTypical watts RMS Typical amps RMS Mode At nominal voltage Typical current profilePower recovery Power-management modesConducted noise Voltage toleranceTemperature gradient Environmental tolerances Ambient temperatureRelative humidity Altitude ShockOperating shock Nonoperating shockMode Typical Nonoperating vibrationDrive acoustics ReliabilityAgency certification Safety certification FCC verificationMarathon 810 ST9816AG Product Manual, August Handling and static-discharge precautions Drive mounting and configurationJumper settings Master/slave configuration Connector and master/slave jumper setup for the ST9816AG Jumper For pins Configuration Remote LED configurationDrive mounting Mounting dimensions for the ST9816AG ATA interface connector Dimensions are in inches mmPage AT bus signal levels ATA interface signals and connector pinsATA interface O pins and associated ATA signals supported by the ST9816AG ATA Interface commands Supported ATA commands NOPATA-standard power-management commands Command Supported by Command name Code ST9816AGSeagate-specific commands Identify Drive command Word Description ST9816AGXxxx H Word Bit Description if bit is set to Set Features command ECC testing Appendix. Compatibility notes