Seagate 810 manual Introduction

Page 9

Marathon 810 (ST9816AG) Product Manual, August 1995

1

 

 

 

Introduction

The Marathon810 (ST9816AG) provides high storage capacity in a small, low-profile hard disc drive.

Key features:

SafeRiteshock protection

Low power consumption

Compact, MCC-compatible form-factor

Quiet operation

Advanced partial-response, maximum-likelihood (PRML) read channel

Supports logical block addressing

Supports PIO modes 0, 1, 2, 3 and 4, and DMA modes 0, 1 and 2.

High instantaneous data-transfer rates (up to 16.6 Mbytes per second using PIO mode 4 and DMA mode 2).

Fast microprocessor for lower command overhead

120-Kbyte multisegmented adaptive cache

Advanced caching and on-the-fly error-correction algorithms

Supports Read Multiple and Write Multiple commands

Supports autodetection of master/slave drives using cable select and DASP– signals.

Image 9
Contents Marathon ATA Interface Drive Page Marathon 810 ST9816AG ATA Interface Drive Page Contents Drive mounting and configuration ATA interface Appendix. Compatibility notes Figures Page Introduction Drive Specification ST9816AG Specification summary tableRead/Write power and current typical Page Default logical geometry Drive specificationsFormatted capacity Supported translation geometriesRecording and interface technology Physical dimensionsPower consumption Power specificationsSeek time Startup timesTypical current profile Typical watts RMS Typical amps RMS Mode At nominal voltagePower-management modes Power recoveryConducted noise Voltage toleranceEnvironmental tolerances Ambient temperature Temperature gradientRelative humidity Shock AltitudeOperating shock Nonoperating shockNonoperating vibration Mode TypicalDrive acoustics ReliabilityFCC verification Agency certification Safety certificationMarathon 810 ST9816AG Product Manual, August Drive mounting and configuration Handling and static-discharge precautionsJumper settings Master/slave configuration Connector and master/slave jumper setup for the ST9816AG Remote LED configuration Jumper For pins ConfigurationDrive mounting Mounting dimensions for the ST9816AG Dimensions are in inches mm ATA interface connectorPage ATA interface signals and connector pins AT bus signal levelsATA interface O pins and associated ATA signals supported by the ST9816AG NOP ATA Interface commands Supported ATA commandsCommand Supported by Command name Code ST9816AG ATA-standard power-management commandsSeagate-specific commands Word Description ST9816AG Identify Drive commandXxxx H Word Bit Description if bit is set to Set Features command Appendix. Compatibility notes ECC testing