Samsung 20041112182436906 instruction manual AUX Connections, FM antenna connection

Connecting the FM and AM(MW/LW) Antennas

1	2	3	If AM reception is
			poor, connect an
			outdoor AM
GB			antenna(not
			supplied).

AM Loop Antenna

(supplied)

ANTENNA

If FM reception is poor,

connect outdoor FM antenna

(not supplied).

FM Antenna (supplied)	Snap the tabs on the loop into the
	slots of the base to assemble the
	AM loop antenna.

R-REAR-L	WOOFER	CENTER	R-FRONT-L
			IMPEDANCE

Cooling fan (See “About Cooling Fan” below.)

AUX Connections

GB

External Digital

Components

For connection to external equipment with digital output.

Example: CD recorders, MD (Mini Disc) D/A converters or other components equipped with digital output jacks

DIGITAL OUT

Optical Cable

R-FRONT-L

Video Cable

IMPEDANCE

Audio Cable (Red/White)

If the external analog

component has only one

output jack, you may

connect either L or R.

External Analog

FM antenna connection

1.Connect the FM antenna supplied to the FM 75Ω

COAXIAL terminal.

2.Slowly move the antenna wire around until you find a location where reception is good, then fasten it to a wall or other rigid surface.

•If reception is poor, connect an outdoor antenna. Before attaching a 75Ω coaxial cable (with a standard type connector), disconnect the supplied FM antenna.

(About the cooling fan)

A cooling fan is mounted on the rear panel of the center unit to prevent abnormal temperature inside the center unit, thus assuring normal operation. The cooling fan automatically starts rotating to supply external cool air to the inside of the center unit when the internal temperature exceeds the specified limit.

AM(MW) antenna connection

1.Connect the AM loop antenna supplied

to the AM and terminals.

2.If reception is poor, connect an outdoor single vinyl-covered wire to the AM terminal. (Keep the AM loop antenna connected).

For safety, observe the following carefully.

•Make sure there is good ventilation around the center unit. Poor ventilation could overheat and damage the canter unit.

•DO NOT block the cooling fan and the ventilation openings or holes. (If they are blocked by a newspaper or cloth, etc., the heat may not be able to escape.)

	Components
	R	L
	Connect to external equipment with		• Always connect the video and
	analog output.		audio connection cables to the
	Example: Video, TV, LDP, etc.		equivalent colored jack.
	Making Analog Input Selection
Remote Control	Press the AUX button and select AUX1 IN, AUX2 IN.
Main Unit	Press the Function button and select AUX1 IN, AUX2 IN.

11 12