12 | Barracuda 5400.1 Product Manual, Rev. G |
2.9.2Conducted noise
Input noise ripple is measured at the host system power supply across an equivalent
•Using
•Using
Note. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current.
2.9.3Voltage tolerance
Voltage tolerance (including noise):
5V ± 5%
12V ± 10%
2.9.4Power-management modes
The drive provides programmable power management to provide greater energy efficiency. In most systems, you can control power management through the system setup program. The drive features the following power- management modes:
Power modes | Heads | Spindle | Buffer |
|
|
|
|
Active | Tracking | Rotating | Enabled |
|
|
|
|
Idle | Tracking | Rotating | Enabled |
|
|
|
|
Standby | Parked | Stopped | Enabled |
|
|
|
|
Sleep | Parked | Stopped | Disabled |
|
|
|
|
•Active mode
The drive is in Active mode during the read/write and seek operations.
•Idle mode
The buffer remains enabled, and the drive accepts all commands and returns to Active mode any time disc access is necessary.
•Standby mode
The drive enters Standby mode when the host sends a Standby Immediate command. If the host has set the standby timer, the drive can also enter