Westinghouse LCM-22W2 user manual Safety Guidelines

Page 4

Safety Guidelines

CAUTION: The power supply outlet should be located near the LCD Monitor and should be easily accessible. Always use the appropriate AC cord that is certified for your specific country. Some examples are listed below:

USA

UL

Switzerland

.........SEV

Canada

CSA

Britain

BASE/BS

Germany

VDE

Japan

Electric Appliance Control Act

IMPORTANT NOTICE CONCERNING POWER CORD SELECTION

The specific power cord for this LCD Monitor is enclosed and has been selected according to the country of destination and must be used to prevent electric shock. Use the following guidelines if it is necessary to replace the original cord set, or if the cord set is not enclosed. The female receptacle of the cord set must meet IEC-60320 requirements and should look like Figure A1 below:

Figure A1

Figure A2

For the United States and Canada

In the United States and Canada the male plug is a NEMA5-15 style (Figure A2), UL Listed, and CSA Labeled. For LCD Monitors that are placed on a desk or table, type SVT or SJT cord sets may be used. For LCD Monitors placed directly on the floor, only SJT type cord sets may be used. The cord set must be selected according to the current rating for the LCD Monitor. Please consult the table below for the selection criteria for power cords used in the United States and Canada.

Cord Type

Size of Conductors in Cord

Maximum Current Rating of Unit

 

 

 

 

18 AWG

10 Amps

SJT

16 AWG

12 Amps

 

14 AWG

12 Amps

SVT

18 AWG

10 Amps

17 AWG

12 Amps

 

FCC Compliance Statement

This equipment has been tested and complies with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and may cause harmful interference to radio communications if not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the LCD Monitor and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the Westinghouse Service Center or an experienced radio/Monitor technician for assistance.

FCC Warning

To assure continued FCC compliance, the user must use a grounded power supply cord and the provided shielded video interface cable with bonded ferrite cores. If a BNC cable used, use only a shielded BNC (5) cable. Also, any unauthorized changes or modifications not expressly approved by Westinghouse Digital will void the user's authority to operate this device.

3

Image 4
Contents USER’S Manual Contents Important Product Safety Instructions Safety Guidelines Cleaning the LCD Monitor To clean the screenTo clean the case DisclaimerFeatures Power SaverPackage Contents InstallationAttaching the Base Stand to the LCD Monitor Connect Inputs PC Inputs at bottomConnect Power Cable Turn the Power OnControl Panel Buttons Green NormalOSD Menu Functions Image Menu while in A/V inputs DLCAudio Menu Color Menu Miscellaneous Menu while in A/V inputs OSDImage Menu while in PC inputs Miscellaneous Menu while in PC Inputs Info Menu while in PC Inputs Appendix No Power No Screen ImageOut Of Range Fuzzy ImageNo sound Colors are IncorrectAdditional Questions Westinghouse Digital Electronics