CHAPTER
4
TROUBLESHOOTING
If you are experiencing trouble with your touchmonitor, refer to the following table. If the problem persists, please contact your local dealer or our service center.
Solutions to Common Problems
| Problem | Suggestion(s) |
| The monitor does not respond | Check that the monitor’s Power Switch is on. |
| after you turn on the system. | Turn off the power and check the monitor’s power cord |
|
| and signal cable for proper connection. |
| Characters on the screen are dim | Refer to the About Touchmonitor Adjustments section to |
|
| adjust the brightness. |
| The screen is blank | During operation, the monitor screen may automatically turn |
|
| off as a result of the Power Saving feature. Press any key to see |
|
| if the screen reappears. |
|
| Refer to the About Touchmonitor Adjustments section to |
|
| adjust the brightness. |
| Screen flashes when initialized | Turn the monitor off then turn it on again. |
| “Out of Range” display | Check to see if the resolution of your computer is higher than |
|
| that of the LCD display. |
|
| Reconfigure the resolution of your computer to make it less |
|
| than or equal to 800x600. See Appendix A for more information |
|
| on resolution. |
| Touch doesn’t work | Make sure the touch cable is securely attached at both ends. |
|
|
|