CS196 EN 17/2/06 7:29 PM Page 22
Radio
EN Selecting Tuner Band
1.Press SOURCE to enter Tuner mode.
2.Press BAND/ INFO to select between FM MW or LW Radio band.
automatic upon pressing the button. You can stop the automatic scan by pressing any button, but the erased stations cannot be recovered.
FM
AUTO
Tuning to a Station
Press 
or 
to select frequencies. Press
and hold 
or 
to scan frequencies.
Using Presets
The tuner can be in either TUNE or PRESET mode.
•Press 
to toggle TUNE and PRESET
mode until “Program” lights on the display.
•Press 
or 
to access the previous or next preset station.
FM02 | Program |
91.10MHZ | |
|
|
Tips: |
|
Under PRESET mode, press | or |
can only acess the preset stations. Manaully tuning is not accessible in this mode.
Auto Preset Programming (FM only)
Press and hold the BAND/ INFO button for 2 seconds to scan stations in FM band. The stations will then be stored as preset channels. A maximum of 32 stations can be stored. Beware of your preset channels being erased accidentally because the scanning and storing process is
Manually Setting Presets
1. Press the button to enter TUNE mode.
2.Press 
or 
to access the desired frequency.
3.Press the PROG button once and the most recently accessed program location flashes on the display.
P:02
91.10MHZ
4. If a different program location is preferred,
press 
or 
to move to the desired preset number
5.Press PROG to store the selected frequency at that preset.
Suppressing Stereo Signal
Press FM ST to toggle between FM mono and stereo mode. (Remote Only) “STEREO” is displayed in stereo mode.
15 