Tyco 1939L manual Installing the Serial Touch Driver for MS-DOS and Windows

Page 12

Installing the Serial Touch Driver for MS-DOS and Windows 3.1

You must have a DOS mouse driver (MOUSE.COM) installed for your mouse if you wish to continue using your mouse along with your touchmonitor in DOS.

To install Windows 3.x and MS-DOS from Windows 95/98, follow the directions below:

1Insert the CD-ROM in your computer’s CD-ROM drive.

2From DOS, type d:\EloDos_W31 to change to the correct directory on the CD-ROM (your CD- ROM drive may be mapped to a different drive letter).

3Type install and press Enter to start the installation.

4Align the touchscreen.

You must have already completed Steps 1 and 2 before proceeding.

To run the INSTALL program:

1Type INSTALL at the DOS prompt in the directory containing the driver install files.

2INSTALL asks you to select the software to install. Then choose d:\EloDos_W31 from the displayed list.

3INSTALL also asks you for the paths to use during installation, or you may use its defaults. INSTALL creates directories as necessary, and warns you if they exist.

If you are updating your software, you may wish to specify the paths containing the earlier versions, and overwrite the obsolete files. All executable programs are upward compatible. For a list of differences from each previous version of the drivers, be sure to select "Differences from Previous Versions" during the installation process.

INSTALL updates your AUTOEXEC.BAT file with the drivers you select. INSTALL makes a copy of your original AUTOEXEC.BAT file, called AUTOEXEC.OLD. If you already have Elo driver commands in your AUTOEXEC.BAT file, they will be commented out.

When INSTALL is finished, it leaves a file called GO.BAT in the subdirectory you specified. GO loads the touchscreen driver, runs the calibration program ELOCALIB, and gives you some final instructions.

If you are using Windows 3.1, you will also calibrate the touchscreen within Windows 3.1 with the Touchscreen Control Panel.

2-14 User Guide

Image 12
Contents Touchmonitor User Guide User Guide 1939L Family 3000 Series Revision CDisclaimer Trademark AcknowledgmentsTable of Contents Precautions IntroductionProduct Description About the Product Installation and Setup Unpacking Your TouchmonitorTouch Interface Connection Product Overview Main Unit Rear ViewInstalling the Driver Software Installing the Serial Touch Driver Click Start RunInstalling the Serial Touch Driver for MS-DOS and Windows Installing the USB Touch Driver User Guide About Touchmonitor Adjustments OperationPower Switch Rear Panel ControlsRemote OSD Buttonsoption Control Function Menu/ExitControls and Adjustment On Screen Display OSD Menu FunctionsOn Screen Display OSD Control Options Preset Modes Freq Band Width Mode Resolution KHz MHzPower Management System PowerMode Consumption Troubleshooting Solutions to Common ProblemsProblem Suggestions User Guide Native Resolution User Guide Touchmonitor Safety Care and Handling of Your Touchmonitor Technical Specifications Touchmonitor Specifications IntelliTouch Touchscreen Specifications Expected Life PerformanceCarrollTouch Infrared Touchscreen Specifications ElectricalSurface Capacitive Touchscreen Specifications SecureTouch Touchscreen Specifications Expected LifeAccuTouch resistive Touchscreen Specifications LCD Touchmonitor ET1939L-XCWA-X-G Dimensions Electrical Safety Information Regulatory InformationII. Emissions and Immunity Information User Guide MPR User Guide Warranty User Guide Index D E X Page Check out Elo’s Web site