Tyan Computer B5381 manual Safety Information

Page 8

SAFETY INFORMATION

Before installing and using the Tank GT25, take note of the following precautions:

Read all instructions carefully.

Do not place the unit on an unstable surface, cart, or stand.

Do not block the slots and opening on the unit, which are pro- vided for ventilation.

Only use the power source indicated on the marking label. If you are not sure, contact the power company.

The unit uses a three-wire ground cable, which is equipped with a third pin to ground the unit and prevent electric shock. Do not defeat the purpose of this pin. If your outlet does not support this kind of plug, contact your electrician to replace your obsolete outlet.

Do not place anything on the power cord. Place the power cord where it will not be in the way of foot traffic.

Follow all warnings and cautions in this manual and on the unit case.

Do not push objects in the ventilation slots as they may touch high voltage components and result in shock and damage to the components.

When replacing parts, ensure that you use parts specified by the manufacturer.

When service or repairs have been done, perform routine safety checks to verify that the system is operating correctly.

Avoid using the system near water, in direct sunlight, or near a heating device.

Cover the unit when not in use.

iv

Image 8
Contents Tank GT25 B5381 Service Engineer’s Manual Page Table of Contents Page Preface Federal Communications Commission FCC About this Manual Safety Information Overview About the Tank GT25 B5381Features EnclosureBios Unpacking Opening the BoxBox Contents Component Description Component Description Accessories Rail Kit Front View Rear View Case a Single PowerAbout the Product Case B Redundant Power LED Definitions Front PanelRear I/O LED Internal View Overview Motherboard Block Diagram Motherboard Layout Jumpers & Connectors Jumper Function ConnectorOverview Page Tools Before You BeginWork Area Precautions Rack mounting kit Installing the Server in a RackRack Mounting Installing the Inner Rails to Chassis Installing Outer Rails to the RackLocate the front and rear brackets Mounting Bracket Rackmounting the Server Setting Up Installing Motherboard Components Removing the Chassis CoverInstalling the Memory Setting Up Installing the CPU and Heatsink Setting Up Setting Up Installing the PCI-X Card Installing the External Hard Drive Setting Up Installing the Slim FDD Optional Setting Up Setting Up Replacing Pre-Installed Components IntroductionPrecautions Disassembly Flowchart Following flowchart outlines the disassembly procedureRemoving the Cover Disconnecting All Motherboard Cables Replacing Motherboard ComponentsRemoving the Motherboard Replacing the Slim DVD-ROM Replacing Pre-Installed Components Replacing the LED Control Board Replacing Pre-Installed Components Replacing the M1210 Adapter Board Remove six screws to release the adapter board 1 M1210 Adapter Board Features for B5381 3 M1210 Adapter Board Connector Pin Definitions System Fan LayoutFAN Signal Related Connector Pin Definitions FAN5TACH GND FAN6TACH FAN9TACH GND FAN10TACH FAN13TACH GND FAN14TACH Replacing the Redundant to Single Power Supply Replacing Pre-Installed Components Replacing a Redundant Power Supply Page Bios Main Menu IDE Primary Menu Boot Features Menu Advanced Main Menu FBD Memory Configuration Menu PCI & Pcie Control Menu USB Control Menu Advanced Processor Control Menu Device Configuration Menu DMI Event Logging Menu Hardware Monitor Menu Voltage Monitoring Menu Fan Speed Monitoring Menu Temperature Monitoring Menu Security Menu Power Menu Boot Menu Exit Menu Appendix II Cable Connection Tables Other Cables Appendix III Memory Population Rules Technical Support Help ResourcesReturning Merchandise for Service