Tyco 0-1591700-x user manual Connecting To The Access Point, Internet Protocol Properties Screen

Page 11

Wireless Access Point Model 0-1591700-x

User Manual

Page 11 of 33

6.This Internet Protocol (TCP/IP) Properties screen is used to specify the IP address of the PC. Note that the access point and PC addresses must be in the same subnet. The default IP address for the access point is 192.168.1.1 and the default subnet mask is 255.255.255.0

7.Although the access point is set by default to be a DHCP server, it is probably best to specify the IP address of the connected PC rather than let the access point allocate IP addresses.

Figure 5 - Internet Protocol Properties Screen

8.For configuration purposes, select the Use the following IP address radio button and enter the information below to place the PC in the same default IP subnet as the access point for the configuration. A suitable IP address for the PC is 192.168.1.10. The subnet mask value is 255.255.255.0. The Default gateway and DNS settings can be left blank at this stage.

9.When the settings have been applied, select OK and the PC will use the new settings.

Connecting To The Access Point

1.Connect the PC network port to the LAN port of the access point using the supplied cross-over cable.

2.The Local Area Connection icon in the PC task bar should now indicate that the PC has a valid Ethernet network connection of the access point.

3.To test that a valid connection has been obtained between the PC and the access point, open the web browser and enter the IP address 192.168.1.1 of the access point into the browser.

4.The web browser should now show the access point log-in screen similar to the image below:-

Figure 6 - Web Browser Log-in Screen

PL0356

©2003TycoElectronics

Issue 1

Image 11
Contents Part Number Table Of Contents Ssid Wireless MenusWPA Key Features and BenefitsIntroduction Supplied ItemsGeneral Operational Requirements FCC ComplianceDeclaration of Conformity Other Regulatory StatementsSupport WarrantyDisclaimer Location Guidelines Installation PracticeWlan Security Do I Need a Site Survey ?Indicator Function Power Access Point PortsLED Indicators ResetUnit Information Wall Mounting the Access PointDesk Mounting the Access Point Getting Started Configuring your PCInternet Protocol Properties Screen Connecting To The Access PointAccess Point Main Screen Wireless Configuration Menu- Basic Settings Serial Console Menu Telnet Menu Menu SystemsWeb Browser Menu Idle Time Out Administrator SettingsPassword Settings System MenuTftp Upgrade Firmware UpgradeRestore Factory Default Configuration Configuration ToolsWeb Upgrade Status ResetBackup Settings / Restore Settings IP Address LAN SettingsDhcp Settings LAN MenuDhcp Client List DNS SettingsFiltering Menu MAC Address Filtering Access Control ListFiltering Mode Function 11a Menu Option Wireless MenusMenu Mode Function Wireless ModeAdvanced Settings Authentication 802.1X Re-authentication TimePrimary Radius Server Authentication Server IP Short Preamble 802.11g Menu OptionProtection Type Protection Mode802.11g Stations Only Protection Rate802.1x Status Status Menu OptionCommunity Access RightSnmp Menu Snmp CommunityGenerated Traps Snmp TrapSnmp MIB Support Ping 192.168.1.1 -t Fault-Finding and FAQs255.255.255.0 Pin No Power Function Power SuppliesCSMA/CA Product Specifications