Seagate ST34501FC manual

Page 5

Cheetah 4LP FC Installation Guide, Rev. B

3

 

 

first ensure that the method you choose will not risk either your safety or unit performance.

Always observe the following warnings and precautions:

Perform all maintenance by following the procedures in this manual.

Follow all cautions and warnings in the procedures.

Use sound safety practices when operating or repairing the unit.

Use caution when troubleshooting a unit that has voltages present. Turn off power to the unit before servicing it.

Wear safety shoes when removing or replacing heavy parts.

Ensure that the internal temperature of the rack or cabinet does not exceed the limits defined for the drive when the drive is mounted in an equipment rack or cabinet. When units are stacked vertically, pay special attention to the top where temperatures are usually highest.

Follow the precautions listed above in “Electrostatic dis- charge protection.”

Do not remove any circuit boards from the drive chassis. Return the entire drive for depot repair if any circuit board is defective. Removal of circuit boards by personnel not per- forming depot repair will damage components and may void the warranty.

As a component, the drive is designed to be installed and oper- ated in accordance with UL1950, IEC950, CSA C22.2 950-M89, and VDE0805 and EN60950.

Seagate takes all reasonable steps to ensure that its products are certifiable to currently accepted standards.

Image 5
Contents Page Contents Electrostatic discharge protection PrefaceImportant safety information and precautions Page Wichtige Sicherheitshinweise Page Cheetah 4LP FC Installation Guide, Rev. B Page Electromagnetic susceptibility Regulatory agency complianceElectromagnetic compliance for the European Union Online services Seagate technical support servicesSeagate CompuServe forum SeaFAX FAX servicesSeagate technical support Direct-support servicesManufacturer’s representatives Customer service centersCheetah 4LP FC disc drive General descriptionCharacteristics ST34501FC Providing adequate cooling Installing the Cheetah 4LP FC driveKühlung des Systems Suggested air flow Abbildung 2. Empfohlener Luftstromverlauf Mounting the drive Installation des LaufwerkesDimensions Abbildung 3 Laufwerkabmessungen Formatting the drive Inserting the driveEnabling write cache Connecting remote LEDsLED indicator connector J6 FC-SCA pin descriptions SEL2 General installation troubleshooting TroubleshootingPage