Installation: Unpacking and Mounting
Unpacking
There are no special unpacking precautions. However, it is recommended you keep the original packing material for reuse in the rare event that service be required. If service is required and the original packing material is not available, ensure that the unit is adequately protected for shipment (strong box of appropriate size , sufficient packing material to prevent load-shifting or impact damage).
What is included in the carton:
Item | Description | Quantity |
1- | DSP-30 Digital Signal Processor | 1 |
2- | Self-adhesive rubber feet | 4 |
3- | Hardware Manual (this document) | 1 |
4- | Signal Manager Software CD | 1 |
5- | IEC Power Cord 3 x #18 AWG | 1 |
6- | RS-232 cable (6 ft.) | 1 |
Mounting
The DSP-30 can be used in or out of an equipment rack. Adhesive rubber feet are included for non-rack mount installations. Use them to prevent the unit from scratching or marring support surfaces.
Rack Mounting
Rack mount the DSP-30 by support- ing it from underneath while align- ing the mounting holes with the threaded screw holes in the rails; install all four mounting screws and washers and tighten securely. Ensure use of all four mounting screws in order to minimize the chance of bending or distorting the rack mount ears. Rack mounting is optional.
Support the Rear for Portable/Mobile Installations
If the DSP-30 is to be transported while in a rack, we recommend supporting the rear of the chassis. This will help prevent the unit from being damaged from the increased mechanical stresses of portable and mobile use. The DSP- 30’s chassis includes integral rear mounting tabs for securing to the rack mounting ears.