Omnitron Systems Technology 12/08 warranty Nmm, Model Description

IP-less management requires an NMM in the core chassis, and a media converter with integrated management installed at each remote end of the IP-less managed link. An iConverter10/100M2 plug-in module is installed in the 19-Module chassis, and connected via the fiber link to a standalone 10/100M2 Network Interface Device (NID). This configuration enables the 19-Module master chassis to establish an IP-less management channel between the 10/100M2 link partners. The IP address resides only at the network core, and does not exist on the customer network.

Model Type	NMM
Protocols	IP, UDP, SNMPv1, SNMPv2c, SNMPv3,
	Telnet, TCP, FTP, ARP, ICMP, 802.3ah
Connectors	RJ-45, DB-9
Controls	UTP cross-over, Frontplane / Backplane
LED Displays	Power, Power Supply (3), UTP link,
	Master, Slave, Mgt. Poll
Supported MIBs	RFC1155, RFC1156, RFC1157,
	RFC1212, RFC1213, OST MIB
Dimensions	W:0.85" x D:4.5" x H:2.8"
Weight	8 oz.
Compliance	UL, CE, FCC Class A, NEBS 3

Active Controls

•Link Propagate/Link Segment

•Remote Fault Detection

•Module Name

•Chassis Name and Number

•IP Address

•802.3ah OAM Enable

•Secure IP-less OAM Enable

•Subnet Mask

•Gateway

•Management Port Disable

•Alarm Threshold Setting

•Download Software via FTP

•Reset Chassis

•Telnet

•Trap IPs

•FTP Enable

•Password Selection

•Soft Switch Reload

Alarms / Traps

•Warm Start

•Link Up/Down

•Chassis Insertion/Removal

•Authentication Failure

•DIP-Switch Configuration Change

•Software Configuration Change

•Temperature Out-of-Range

•Power Supply Out-of-Range

•Power Supply Insertion/Removal

•Chassis Reset

•Module Reset

•Module Insertion/Removal

•Port Link State Change

•Redundancy Primary Up/Down

•Redundancy Secondary Up/Down

•FTP Session Open/Close

•Telnet Session Open/Close

•Dying Gasp (Power Loss Trap)

Chassis Information

•Part Number

•Serial Number

•Revision

•Description

Chassis Status

•Power Status

•Power Output Voltage

•Chassis Temperature

Module Status

•Module Power

•Link Status

•Active Port

•Diagnostic Status

•Management

Module Information

•Module Type

•Slot Occupied

•Part Number

•Serial Number

•Configuration

•Revision

•Ports on Module

•User-defined Identifier

Power Requirement	0.32A @ 3.3VDC (typical)
Temperature	Standard:	0 to 50º C
	Wide:	-40 to 60º C
	Storage:	-40 to 80º C
Humidity	5 to 95% (non-condensing)
Altitude	-100m to 4000m
MTBF (hrs)	786,000

Model	Description
8000-0	iConverter NMM Module w/ Dying Gasp Support
8080-3	NMM Cascade Cable (3 ft.)
8081-3	NMM Serial Cable (DB-9, 3 ft.)

Trademarks are owned by their respective companies. iConverter and NetOutlook are registered trademarks of Omnitron Systems Technology, Inc. Specifications subject to change without notice. ©2008 Omnitron Systems Technology, Inc. All rights reserved.

091-18000-001H 12/08

800-675-8410 • 949-250-6510 • www.omnitron-systems.com • info@omnitron-systems.com • 140 Technology Dr. • Irvine, CA 92618