Omega Vehicle Security OMG-COMM2-EX manual Appendix F Compliance Notices

Page 20

Appendix F - Compliance Notices

Appendix F - Compliance Notices

Federal Communications Commission Statement

FCC - This equipment has been tested and found to comply with the limits for Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in such case the user will be required to correct the interference at his own expense.

EMC Directive Statement

Products bearing the CE Label fulfill the requirements of the EMC directive (89/336/EEC) and of the low-voltage directive (73/23/EEC) issued by the European Commission.

To obey these directives, the following European standards must be met:

EN55022 Class A - “Limits and methods of measurement of radio interference characteristics of information technology equipment”

EN55024-‘Information technology equipment Immunity characteristics Limits and methods of measurement.

EN60950 (IEC950) - “Safety of information technology equipment, including electrical business equipment”

Warning

This is a Class A Product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Always use cabling provided with this product if possible. If no cable is provided or if an alternate cable is required, use high quality shielded cabling to maintain compliance with FCC/EMC directives.

OMG-COMM2-EX

Page 16

Image 20 Contents
User’sGuide Canada MexicoBenelux Czech RepublicContents Figures Factory Default Settings IntroductionOverview What’s IncludedCard Setup Address SelectionPort Enable / Disable Interface Selection RS-422/485RS-232 IRQ SelectionInterrupt Modes E10Headers E3 and E4 Headers E9 and E10, Sharing IRQ’s with another adapterOther Operating Systems InstallationOperating System Installation For Windows Users Features Modem Control Signal ConsiderationsTechnical Description Line TerminationConnector Pin Assignments RS-232 Male DB9 RS-422/485 Male DB9Specifications Appendix a Troubleshooting Appendix B How To Get Assistance Appendix C Electrical Interface RS-422RS-485 Asynchronous Communications Bit Diagram Appendix D Asynchronous CommunicationsAppendix E Silk-Screen Appendix F Compliance Notices WARRANTY/DISCLAIMER Temperature