Rear Panel
PRINTERNETWORK
12V DC
Label | Function | Description |
|
|
|
PRINTER | Parallel | Accepts an IEEE1284 printer cable that connects |
| Printer Port | to the printer. |
|
|
|
NETWORK | 10/100 | |
|
| connection to a 10 Mbps or 100 Mbps port on a switch |
| Network Port | or hub. |
|
|
|
A small | Diagnostic | Briefly pressing the button has no effect. Pressing the |
button | and Restore- | button for two seconds will print the status of the print |
with no | server, including wired and wireless information, on the | |
label | Button | attached printer. |
|
| Note: This is the best way to obtain the IP address |
|
| of the print server, since the default setting for the |
|
| PS111W is DHCP. |
|
| Turn the power off, hold the Reset Button. |
|
| Powering on the print server and holding this button for |
|
| more than 10 seconds will restore the print server to the |
|
| factory default settings. |
|
| Warning: You will lose the current configuration in |
|
| the PS111W, so use this function with care. |
|
|
|
12V DC | Power Supply | Accepts the 12V 800mA power supply. |
| Inlet |
|
|
| Note: NETGEAR advises that you use genuine |
|
| NETGEAR accessories to avoid damaging the unit. |
|
| For part |
|
| Power Adapter section at the end of this guide. |
|
|
|
5