Connect the Network Cables

1.Using a UTP cable, connect any port on the hub to the port on the RJ- 45 adapter cable.

2.To connect the network cables, follow the illustration below.

Note: One of the ports on NETGEAR hubs is switchable between Normal (MDI-X) and Uplink (MDI) with a Normal/Uplink push button. If you are using this switchable port on a NETGEAR hub to connect to a PC or the network card, make sure the Normal/Uplink push button is set to Normal.

PC with network card installed

Hub

Power adapter

RJ-45 connectors

Notebook PC

Model FA510 Network Card with RJ-45 adapter cable

Category 5 10/100 Mbps UTP cables*

*Use the cable provided or any Category 5 UTP cable. Maximum length = 100 meters (300 feet)

9026FA

Model FA510 Network Card Installation Guide