NETGEAR GSM712 manual Checking the Installation, Applying AC Power

Page 16

Figure 3-2. Installing a Gigabit Ethernet Module

Figure 3-3. Installing a Gigabit Ethernet Module

Step 4: Checking the Installation

Before you apply power:

oInspect the equipment thoroughly.

oVerify that all cables are installed correctly.

oCheck cable routing to make sure cables are not damaged or are a safety hazard. o Be sure all equipment is mounted properly and securely.

Step 5: Applying AC Power

NETGEAR Model GSM712/GSM712F Managed Gigabit Switches do not have an ON/OFF switch; the only method of applying or removing AC power is by connecting or disconnecting the power cord. Before you connect the power cord, select an AC outlet that is not controlled by a wall switch, which can turn off power to the switch. After you select an appropriate outlet, use the following procedure to apply AC power.

Page 15 of 24

Image 16

Contents Page Trademarks Statement of ConditionsCertificate of the Manufacturer/Importer Voluntary Control Council for Interference Vcci StatementCustomer Support Internet/World Wide WebContents Figures Introduction OverviewFeatures Package Contents GSM712 Package ContentsGSM712F Package Contents Verify that your package contains the followingPhysical Description Front and Black Panels10/100/1000 Mbps RJ-45 Ports Gigabit Ethernet Ports RJ-45 and Gbic Module Bays LED DescriptionsLabel Color Activity Description Max SpdConsole Port Installing the Switch InstallationPreparing the Site Installing a Gbic Module Installing the Switch in a RackChecking the Installation Applying AC PowerPage System Information On the Main Menu page, hit the ‘C’ key to select the Set-Up Nvram Connecting Devices to the Switch GSM712 Connecting Devices to the SwitchAppendix a Technical Specifications Electromagnetic Emissions Electromagnetic Immunity SafetyModules Troubleshooting Chart Appendix B TroubleshootingAdditional Troubleshooting Suggestions Appendix C Default Settings 0 1 3 0 0