NETGEAR EN104TP manual Connect Devices to the Hub

Page 7

Connect Devices to the Hub

You can connect PCs, Apple Macintosh computers, UNIX workstations, or any device equipped with a 10BASE-T Ethernet interface to the RJ-45 ports on your hub by using twisted pair Ethernet cables.

To connect any of the RJ-45 ports on your hub to a PC, use a regular straight- through UTP cable. If you are connecting using port 4 on the Model EN104TP hub, port 6 on the Model EN106TP hub, or port 8 on the Model EN108TP hub, set the Normal/Uplink push button to Normal.

(The Model EN106TP hub is

shown in the illustration.)

8726FA

Note: Ethernet speciﬁcations limit the cable length between your PC or server and the hub to 328 feet (100 meters) in length.

Model EN104TP/EN106TP/EN108TP Ethernet Hub Installation Guide

Image 7

Contents Page Start Here FeaturesPackage Contents Vista 10BASE-T Network Ports with Built-in LEDs Product IllustrationLabel Color Activity Description LEDsNormal/Uplink Push Button Rear PanelInstall the Hub Installation Procedures Prepare the SiteCharacteristic Requirement Connect Devices to the Hub Set the Normal/Uplink Push Button Connecting Port Connecting Device Cable Used On the HubConnecting Port Connecting Device Cable Used Connect the Hub to a NetworkModel EN106TP hub Cascade the HubNetwork Interface Cards Verify the InstallationTroubleshooting Symptom Cause SolutionOrder code Replacement Power AdapterHub Integrity Order code EN104TP, EN106TPPower Technical SpecificationsTrademarks EN100TPNA-4