Basic Operations | Clarion DRX8675z instruction

7. OPERATIONS

Basic Operations	Note: Be sure to read this chapter referring to the front diagrams of
	chapter “3. CONTROLS” on page 5 (unfold).

CAUTION

Be sure to lower the volume before switching off the unit power or the ignition key. The unit remembers its last volume setting. If you switch the power off with the volume up, when you switch the power back on, the sudden loud volume may hurt your hearing and dam- age the unit.

The clock is displayed when the ignition key is turned to the ACC (accessory) or IGN (igni- tion-on) position even when the unit power is off. In some cars, the clock may momen- tarily disappear when the ignition key is turned to the START position. The clock will reappear after the engine has started and the ignition key is released to the IGN (ignition- on) position.

Turning on/off the power

Note:

•Be careful about using this unit for a long time with- out running the engine. If you drain the car’s bat- tery too far, you may not be able to start the en- gine and this can reduce the service life of the battery.

Radio mode ➜ CD mode ➜ CD changer mode

➜MD changer mode ➜ TV mode ➜ Radio mode...

∗External equipment not connected with CeNET is not displayed.

Adjusting the volume

Turning the Rotary knob & clockwise increases the volume; turning it counterclockwise de- creases the volume.

∗The volume level is from 0 (minimum) to 33 (maxi- mum).

Switching the display

Press DISP button ! to select the desired display. Each time you press DISP button !, the display switches in the following order:

Main display

1.Press POWER button 3.

2.The illumination and display on the unit light up. The unit automatically remembers its last operation mode and will automatically switch to display that mode.

3.Press and hold POWER button 3 for 1 sec- ond or longer to turn off the power for the unit.

Note:

•System check

The first time this unit is turned on after the wire connections are completed, it must be checked what equipment is connected. When the power is

turned on, “SYSTEM CHCK” appears in the display, so press POWER button 3. The system check starts within the unit. When the system check

is complete, the power is turned off, so press POWER button 3 again.

Sub (title) display

Clock display

Spectrum analyzer display

Selecting a mode

1.	Press FNC button 3 to change the mode of
	operation.
2.	Each time you press FNC button 3, the mode
	of operation changes in the following order:	Main display...
		Main display...

10 DRX8675z