NetComm NP290W manual Safety Summary Messages, Important Safety Instructions

Page 19

Safety Summary Messages

WARNING

HIGH VOLTAGE is used in the equipment. Make sure equipment is properly grounded BEFORE opening. Failure to observe safety precautions may result in electric shock to user.

CAUTION

Check voltages before connecting equipment to power supplies. Wrong voltages applied may result in damage to equipment.

Important Safety Instructions

Please read these instructions carefully:

1.The HomePlug Ethernet Adaptor relies on the building’s electrical installation for short-circuit (over current) protection. Ensure that a fuse or circuit breaker no larger than 120 VAC or 230 VAC (depends on the power supply type in your country) is used on the phase conductors (all current-carrying conductors).

2.Do not attempt to service the HomePlug Ethernet Adaptor yourself, as opening or removing covers may expose you to dangerous voltage points or other risks as well as ruin the product warranty. Refer all servicing to qualified service personnel only.

NP290W User Guide	19
YML849Rev 1

Image 19

Contents User Guide Contents Minimum Requirements Typical NP290W Turbo Wireless HomePlug ConnectionPackage Contents IntroductionLight Indicators and Ports NP290W Turbo Wireless HomePlug OverviewOpen a browser Hardware InstallationTo connect the HomePlug Wireless Adapter with a computer IP Address you used if you changed the defaultTo access the Web User Interface Open a browser Using the CD Setup UtilityTo use the CD Setup Utility Accessing the Web User InterfaceConfiguring TCP/IP Locate your wireless network connection icon To connect with wireless devices for Microsoft XPNavigation Menus and Submenus About the Web User InterfaceRetype password Enter Auto-logout Time Click Save Advanced ConfigurationAdministrator Settings Changing the Administrator PasswordLocal HomePlugs Detecting HomePlug DevicesChanging the Private Network Name Remote HomePlugsPrivate Network Name Reset LAN SettingsRestore to Factory Default Firmware UpgradeBackup Settings Reboot Restore SettingsSelect Settings. This opens the Wireless Settings Wireless SettingsSettings To configure the wireless settingsSecurity To configure the wireless security settingsSelect an Encryption Type None Click OK. This takes you back AP ModeDefault Administrator password is admin Then click Connect APTo display the system status DiagnosticsSystem Status System LogImportant Safety Instructions Safety Summary MessagesNP290W User Guide