Niles Audio MSU250 manual Power Status Introduction, Power Status Installation Considerations

I N F R A R E D M A I N S Y S T E M U N I T

Power Status — Introduction

To properly wire an IntelliPad to the MSU250, refer to Figure 5.

By providing 3-30 volt AC/DC to the status input jack of your MSU250 you can send a status signal to sensors or an IntelliPad without running any additional wiring. Built into the MSU250 is a Niles status signal generator. When the MSU250 sees 3-30 volt AC/DC at the status jack it broadcasts a status signal over your existing IR sensor wires. Any sensor or IntelliPad connect- ed to one of your sensor wires will display the power status of your system.

Power Status — Installation Considerations

Proper Power Supply

If status is being supplied from a switched outlet you must con- nect a Niles 12VDC wall adapter (Niles FG00665) into the switched AC power outlet of the preamp/receiver in your system. Any 12VDC power supply with a minimum of 100mA current capacity can be substituted.

13