I N F R A R E D M A I N S Y S T E M U N I T
Installation
Before you begin, make sure that the sensor/keypad cables, the flasher cables and the 12VDC power supply cable will all reach the proposed location of the MSU250. Mark the cables with labels describing where the cable originates (rather than which terminal on the MSU250 it should connect).
For proper installation, follow the steps outlined below in the correct order. If you discover a fault in the course of installa- tion, go on to the Troubleshooting Guide before continuing with the next installation step.
TOOLS
REQUIRED
•1/8" Standard Slotted
Screwdriver
• Wire Stripper
To Niles
IR Flasher
To unswitched
AC Outlet
AC/DC |
STATUS |
IN |
To 12V DC Power
Supply Plugged into
an switched AC Outlet.
Typically found in back of a receiver.
Figure 6:
MSU250
Installation.
MSU250
WS100 Sensor | MSU250 Sensor |
| Connection |
8