Net Optics PAD-CU-AR manual Connecting to the Monitoring Devices, Connecting to Monitoring Devices

Page 13

10/100 Port Aggregator Tap

Connecting to the Monitoring Device(s)

1. . Supply power to the Tap using the power supplies included with the unit. . Two power supplies are included. .The use of the second redundant power supply is optional..

Note:________________________________________________________________

The second power supply is available to support the flow of traffic to the moni- toring device, in the event that the first power supply becomes unavailable. If the first power supply is unavailable, the second power supply will supply all power for the Tap. Even if no power is available to the passive Tap, network traffic flows uninterrupted.

______________________________________________________________________

2.Verify that the Power LEDs illuminate. PWR 1 illuminates when the first power supply is in use, and PWR 2 illuminates when the second power supply is in use. .Both power supplies can be plugged into the Tap at the same time..

3. . Connect Monitoring Port 1 to the appropriate port on the monitoring . device using a CAT5 RJ45 straight-through cable to monitor the full-. duplex link..

4. . If you are installing model PAD-CU-AR, connect Monitoring Port 2 to the appropriate port on the monitoring device using a CAT5 RJ45 straight- through cable to monitor the full-duplex link..

 

A

B

1

2

®

 

 

 

 

Passive Dual

2

 

 

 

Port Aggregator with

1

 

 

 

Active Response

 

 

 

 

10 LINK

10 LINK

10 LINK

10 LINK

www.netoptics.com

100 ACT

100 ACT

100 ACT

100 ACT

To monitoring device 1

To monitoring device 2 (96448)

Figure 8: Connecting to Monitoring Device(s)



Image 13
Contents Installation Guide for Page Contents Trademarks and Copyrights Response Ready IntroductionBuffering Prevents Lost Data Better than Span Ports Simple to DeploySecurity and Visibility ReliabilityPassive, Secure Technology Key FeaturesEnhanced, Efficient Monitoring Ease of UseUnpacking and Inspection Product DiagramsRear Panel LED Indicators80% Utilization Application Diagrams Memory Operation140% Utilization Cabling Guidelines Connecting to the NetworkConnecting to Monitoring Devices Connecting to the Monitoring DevicesSwitch Function Description DIP Switch SettingsWhat types of active responses are supported? Active Response Tap FAQsHow much bandwidth is available on the Active Response Port? Specifications Limitations on Warranty and Liability Page By Net Optics, Inc. .All Rights Reserved