Net Optics PAD-CU-AR, PA-CU-AR manual LED Indicators, Rear Panel

Page 9

10/100 Port Aggregator Tap

DIP Switch

Power DC Jacks

/1 2 3 4 5 6 7 8

.

Figure 3: Rear Panel

LED Indicators

•PWR 1/ PWR 2: Main and Redundant Power. .If the Tap is deployed with both power supplies, both LEDs will illuminate when the Tap is plugged in. . If an LED is off, this indicates that the corresponding power supply is not functioning..

Additional Port Aggregator Tap LEDs are located in the upper left and right hand corners of the RJ45 connectors for Port A, Port B, Port 1 and Port 2 (PAD-CU-AR only)..

•10/100 Indicator: If the Port is set to 10 Mbps, the LED illuminates or- ange. .If the Port is set to 100 Mbps, the LED illuminates green. .

•Link/Activity Indicators: If a good link is established, the LED illu- minates a steady green. .If there is current activity on this link, the LED flashes.



Page 8 Page 10
Image 9
Page 8 Page 10
Contents Installation Guide for Page Contents Trademarks and Copyrights Introduction Response ReadyBuffering Prevents Lost Data Better than Span Ports Simple to DeploySecurity and Visibility ReliabilityPassive, Secure Technology Key FeaturesEnhanced, Efficient Monitoring Ease of UseUnpacking and Inspection Product DiagramsRear Panel LED Indicators80% Utilization Application Diagrams Memory Operation140% Utilization Cabling Guidelines Connecting to the NetworkConnecting to Monitoring Devices Connecting to the Monitoring DevicesSwitch Function Description DIP Switch SettingsWhat types of active responses are supported? Active Response Tap FAQsHow much bandwidth is available on the Active Response Port? Specifications Limitations on Warranty and Liability Page By Net Optics, Inc. .All Rights Reserved
Top Page Image Contents