Contents

Disclaimer

The information in this document is subject to change without notice and does not represent a commitment on the part of the vendor. No warranty or representation, either expressed or implied, is made with respect to the quality, accuracy or fitness for any particular purpose of this document. The manufacturer reserves the right to make changes to the content of this document and/or the products associated with it at any time without obligation to notify any person or organization of such changes. In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential damages arising out of the use or inability to use this product or documentation, even if advised of the possibility of such damages. This document contains materials protected by copyright. All rights are reserved. No part of this manual may be reproduced or transmitted in any form, by any means or for any purpose without express written consent. Product names appearing in this document are mentioned for identification purposes only. All trademarks, product names or brand names appearing in this document are registered property of their respective owners.

Printed in Taiwan

FCC Compliance Statement

This equipment has been tested and found to comply with limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television equipment reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Move the equipment away from the receiver.

-Plug the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/television technician for additional suggestions.

Only equipment certified to comply with Class B should be attached to this equipment, and must have shielded interface cables. You are cautioned that any change or modifications to the equipment not expressly approved by the party responsible for compliance could void your authority to operate such equipment. This device complies with Part 15 of the FCC rule. Operation is subjected to the following two conditions:

1)This device may not cause harmful interference.

2)This device must accept any interference received, including interference that may cause undesired operation.

100%	Nov 2003
	OST-CONSUMER
	RECYCLED PAPER

CONTENTS
Chapter 1 Introduction	1
Product Specifications	1
Package Contents	2
System Requirements	2
Chapter 2 Hardware Setup	3
Installing the Hardware	3
.................................................................................................................	4
Installation du matériel	5
하드웨어 설치	6
Installation der Hardware	7
Chapter 3 Driver Setup	8
Introduction	8
DirectX 9.0	8
Display Drivers Setup	10
Chapter 4 Display properties	12
nView Display Setup	13
Performance and Quality Settings	18
Direct 3D Settings	19
OpenGL Settings	20
Overlay Controls	21
TroubleShooting	22
NVRotate	23
Temperature Setting (For specific products only)	24
Refresh Rate Override	25
Change Resolutions	25
Desktop Management	26
Screen Menus	26
Appendix	27
WinCinema	27
3Deep E-color (Optional)	41
WinProducer3 (Optional)	45