MRV Communications EM316E1, EM316T1 manual Configuration, Jumper Settings Factory Default

Page 10

Fiber Driver

EM316E1/EM316T1

Configuration

Jumper Settings: (Factory Default)

DO NOT CHANGE THE JUMPER SETTINGS BELOW

		JUMPER	SETTINGS	RESULTS

		JP2	OPEN	Factory Use Only

		JP9	OPEN	Factory Use Only

		W1	OPEN	Factory Use Only

		Note: * Jumper settings with asterisk (*) are factory default

P/N: 1218003-001, REV_O				PAGE 10

Image 10

Contents EM316T1 EM316E1 Serial number How many employees work at installation site?Registration Card What network medium/media does your organization use ?EM316E1 EM316T1 Fiber Driver EM316E1/EM316T1 Introduction Product DescriptionFeatures Requirements for Managed ModuleFiber ST, or SC-APC for single fiber Coax BNC 2 connectors 1 for TX, 1 for RXConnectivity Female RJ-48 MDIDisplay Information LED Definition Alarm Indication Signal illuminates when unframed all-onesIlluminates when fiber signal is detected Out of 8129 bit periodsTypical Applications Configuration Jumper Settings Factory DefaultEM316E1 Jumper Settings for E1 120Ω Application EM316E1 Jumper Settings for E1 75Ω Application EM316T1 Jumper Settings for T1 100Ω Application Theory of Operation Hardware Installation Preparation Follow all Safety RegulationsDetermine the best location for the chassis Unpacking the unitUnit Installation Take out the required amount of blank panelsFiber Driver EM316E1/EM316T1 Troubleshooting Technical Specifications Americas Support Customer SupportInternational Support Ordering Information GlossaryFiber Driver Division of MRV Fiber Driver EM316E1/EM316T1