Panel Mounting

WARNING: Do not install the CANdrive module near exhaust manifolds, turbochargers or other engine locations that might exceed the maximum allowable operating temperature of 185°F (85°C).

CANdrive modules are surface-mounted with four no.4 screws, fixing center dimensions as shown. Select screw length according to panel thickness, ensuring a maximum of 1/2 inch (13mm) screw depth into the CANdrive module fixing holes.

Model CDV100F, with forward facing connector, is designed for surface-mounting inside an enclosed panel.

Model CDV300F, with additional LEDs and rearward facing connector, is designed for front-of- panel mounting: these modules require an additional 2.4” x 1.6” (60 x 40mm) cut-out for rear access to connector and links. The CDV300F includes a CDVG gasket (fitted into a well behind the rim of the case) to provide front environmental sealing to IP65.

Before mounting, ensure that the final position allows access for:

•Connection of the included wire harness.

•Configuration of links L1 to L5 (position as shown). Alternatively, ensure that the links are set correctly before mounting. See Configuration section below for full details.

Section 78	00-02-0618
04-10-07	- 5 -