Multi-Tech Systems RF802EW quick start Software Installation

Page 21

Software Installation

16.The Setup Wizard: Modem Setting dialog box re-displays.

Use the Asynchronous port settings list to select the baudrate. Select the DTE speed (the speed of communication between the asynchronous port of the RF802EW and the modem). For DCE speed compression modems, this value can normally be set to about 4 times the speed of your modem. Keep in mind that if you set the baudrate too high, the dial- up connection may fail.

Note: You may need to set a lower baudrate since the theoretical maximum connection speed may not be attainable due to variations in quality of phone line and ISP connection.

Click Next to complete the basic configuration.

21

Image 21
Contents Quick Start Guide Quick Start Guide Contents Related Documentation IntroductionSafety Warnings Hardware InstallationCabling Your RouteFinder Unpacking your RouteFinderRouteFinder Quick Start Guide Using RouteFinder Setup Wizard Software Installation and ConfigurationRouteFinder Quick Start Guide Software Installation Setup Wizard Device IP Address dialog box displays Software Installation RouteFinder Quick Start Guide Click Next RouteFinder Quick Start Guide Use Local Client List Remote AccessUse Radius Server IP Routing NAT Enabled IP Routing NAT Disabled Setup Wizard DNS IP Address dialog box displays Setup Wizard Modem Settings dialog box displays RouteFinder Quick Start Guide Software Installation Click Finish to complete the configuration Software Installation Using Telnet to Configure your RouteFinder Testing Your ConnectionSoftware Installation RouteFinder Quick Start Guide Multi-Tech Warranty & Repair Policies Limited WarrantyService and Technical Support Country By Email By PhoneS0000205
Related manuals
Manual 118 pages 51.53 Kb Manual 28 pages 36.04 Kb