Multi-Tech Systems MT5634ZPX-V.92-ISA manual Using Your Modem, Operating Your MultiModemZPX

MultiModemZPX User Guide 3 Using Your Modem

Chapter 3 - Using Your Modem

Operating Your MultiModemZPX

If you’re an experienced modem user, you may only want to check your modem’s settings for data compression, error correction, and so on. You’ll find you can get moving quite quickly by using a terminal window (you may use HyperTerminal in Windows) to issue the AT&V<cr> command. This command will list your modem’s current configuration, the stored (user) profiles, and the stored telephone numbers. If you come across a setting you’re unsure of, refer to the AT Command Reference Guide for AT commands and S-Register explanations and defaults.

Your MT5634ZPX can be controlled by issuing AT commands and setting S-Registers. Since your MultiModemZPX default settings use a traditional modem set to make a dial-up call to a remote installation where the call is answered automatically—you shouldn’t need to change the current configuration.

In operating your MultiModemZPX, it is likely that you will use your data communications software to either:

•Enter terminal mode, where you can speak most directly to the modem by issuing AT commands, or

•Launch a data communications or Dial-Up Networking session through a set of modem configurations that you select and then associate with a target telephone number.

Testing Your Modem

Testing Data Functions

You can test your modem’s data transfer functions by logging on to Multi-Tech’s Web site to register your modem.

Note: This procedure assumes you have set up a successful dial-up Internet connection and you have a web browser installed on your computer.

1.Make your connection to the Internet.

2.Go to http://www.multitech.com/register/

3.Complete and submit the form.

Testing Fax Functions

Test your modem’s fax capabilities by sending a fax to Multi-Tech or to a fax machine in your office.

Windows 95, 98 and 2000 include a faxing application. If you are using Windows NT and want to fax from your computer, you will need to install a third party faxing application.

The Windows fax application can act as a stand-alone fax program, or it can be used to fax from within an application such as a word processor. If you are using Windows 2000 and are not familiar with the faxing procedure, use the Windows 2000 Help index to find the topic entitled Fax, how to fax a document. If you are faxing from Windows 95 or Windows 98, use the following procedure:

1.Click Start Programs Accessories WordPad.

2.Create a message in WordPad, for example: This is a test of the MultiModemZPX’s fax capabilities.

19