Figure 3-7. Power Receptacles
2.Plug the other end of the cable into a grounded, 3-pin socket, AC power source. Note: For International use, you may need to change the AC line cord. You must use a line cord set that has been approved for the receptacle type in your country.
3.Check the front-panel LEDs as the device is powered on to be sure the PWR LED is lit. If not, check that the power cable is plugged in correctly
4.If you have purchased a Redundant Power Unit, connect it to the switch and to an AC power source now, following the instructions included with the package.
Connecting to the Console Port
The DB-9 serial port on the switch’s back panel is used to connect to the switch for out-of-band console configuration. The command-line-driven configuration program can be accessed from a terminal or a PC running a terminal emulation program. The pin assignments used to connect to the serial port are provided in the following table.
Figure 3-8. Serial Port (DB-9 DTE) Pin-Out
Wiring Map for Serial Cable
19
